Plumbing Tips That Will Greatly Help You Out

Did you know that you can use the same antifreeze that you use in your car to help prevent your home plumbing from freezing? To find out how and why, as well as other great tips for how to maintain your home plumbing, read the following article right away.

Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.





You do not give the plumber all the money until he is finished with his work. Sometimes plumbers will request a cash deposit before any work can commence; however, you avoid paying the total bill until the whole job has been finished to your satisfaction. You will feel better paying the bill when you are completely satisfied with the job.

If your water pipe freezes, switch on the nearest faucet tap to that pipe so that water can exit when the pipe thaws. This will relieve pressure and might prevent the pipe from bursting, preventing further damage.

Some people have problems with their plumbing system in that the pipes sweat and drip condensation. You do not have to hire a plumber to take care of this nuisance. You can purchase self-adhesive drip tape from your local hardware store. This drip tape will insulate your "sweating" pipes which are dripping with moisture built up from condensation. To make sure the tape sticks firmly, dry the pipe thoroughly before applying the tape.

If your pipes are prone to freezing, let the water trickle continuously in at least one faucet during weather that is below freezing. This will minimize the chances that the pipes will freeze and leave you without water. If water is continually running through the pipes and trickling out of a faucet, the pipes are less likely to freeze.

Do you have a frozen drainpipe? You can use a garden hose to thaw it out. First of all, remove the trap from the drainpipe and insert the hose until it will not go any further. While lifting up the other end of the hose, pour hot water down it. Keep pouring hot water down the hose until the drainpipe thaws. To save time with cleanup, keep a bucket underneath to catch the water that overflows.

Cleaning an aerator can remove sediment buildup that causes low water pressure. The aerator should be removed and taken apart. Then, clean with a tiny brush swabbed in vinegar. Thoroughly rinse off the aerator, put it back together and place it back on the faucet. browse this site should help increase the water pressure, because any obstacles in the aerator will have been removed.

Do not be surprised if a plumber charges you more than you expected. Many customers think that fixing a toilet or other drainage problem should be easy, therefore the price should be low. You must remember that not only does a plumber have to charge for labor, but they have to charge for parts that you need.

Do not, under any circumstances, put lemons down your disposal. Although the lemon smell will give your disposal a great smell, its acid can corrode the metal parts in it. Instead, use products that are made specifically for this use. You can purchase these products at most hardware stores or wherever cleaning products are sold.

When plunging a drain to attempt to remove a blockage, first make sure that the drain is completely covered in water. This helps to form a seal. Then, plunge at least fifteen to twenty times before stopping. Repeat the process two to three times. If this doesn't work, try a chemical drain cleaner.

Check for leaks behind the wall tile in your bathroom, especially any tile surrounding your bathtub, by gently pressing each tile and feeling for some give. If you find any mushy or soft spots, you will need to find the source of the leak and repair it to prevent further damage.

It is a general rule of thumb that you should replace a water faucet every seven years, even if you do not see anything wrong with it. Some faucet problems are not visible to the naked eye, which is why it is so important for them to replaced every so often.

To prepare for the cold weather, properly drain all outside faucet bibs and turn off the water supply to those faucets. A piece of foam taped to the outside bib can provide excellent insulation to prevent any remaining water from freezing or splurge for a specialty cover that comes complete with velcro closures.


To keep your drains moving freely and free from gunk and buildup, pour a half cup of baking soda followed by a cup of white vinegar down each drain once a month. Click To See More helps to push stuck substances through the pipe, while the vinegar neutralizes odors. You can follow this solution with a kettle of boiling water for extra cleaning power.

Use a shop vacuum to unplug your toilets or drains, if a hard object is clogging it. Using a plunger will only push the object further and make it impossible to remove. If you do not have a shop vacuum, you can rent one from most Walmart stores or from similar franchises.

Repair a leaky faucet as quickly as possible. Most leaky faucets are caused by a worn or damaged seal, which can easily be replaced, but you need to attend to it quickly. A slow leak can waste up to 20 gallons of water per day, costing a lot of money in the long run. If the faucet is really old, sometimes it's worth replacing the entire fixture.

So, after reading and applying the helpful tips listed above, you should feel a bit more at ease in the land of plumbing. You have the tools; it's time to use them. You should feel empowered and ready to begin your plumbing journey to start taking care of your home's plumbing system.

Leave a Reply

Your email address will not be published. Required fields are marked *